MT-3C Through Hole Welding Positioner

Hollow Bore- 6.69 inch hollow bore allows for long pieces of pipe, shafts, hoses etc.

Welding Chucks- Two model WP-400 self centering 3-jaw welding chucks.

Welding Ground- 500 amps at 50 percent duty cycle.

Tilting- 360 degrees of tilting through a heavy duty worm gear drive allows the work-piece to be positioned at any angle desired.

Table Rotation- Infinitely variable speed with dynamic braking & ten turn potentiometer for fine adjustment.

Controls- On/Off electric foot control. For/Rev switch and speed dial on control box.

Input Power- 120 volts A.C. 60 HZ single phase.

Specifications model MT-3C

Maximum weight capacity………………………….…………………...……...1000 lbs

Tilting center of gravity measured from shaft centerline……………………... 7.8 inches

Rotation Eccentricity @ maximum capacity………………..……….…..…..... 1.2 inches

Rotation Speed…………………………………………………..……….0.25 to 2.5 rpm

Maximum Rotation Torque……………………………………………….. 1200 inch-lbs

Hollow Bore Diameter………………………….…………………….…… 6.69 inches

Optional speed range of 0.1 to 1.0 rpm and 0.5 to 5.0 rpm available