MT-2C Through Hole Welding Positioner

Standard Features MT-2C

Hollow Bore- 3.94 inch hollow bore allows for long pieces of pipe, shafts, hoses etc.

Welding Chucks- Two model WP-300 self centering 3-jaw welding chucks.

Welding Ground- 500 amps at 50 percent duty cycle.

Tilting- 360 degrees of tilting through a heavy duty worm gear drive allows the work-piece to be positioned at any angle desired.

Table Rotation- Infinitely variable speed with dynamic braking & ten turn potentiometer for fine adjustment.

Controls- On/Off electric foot control. For/Rev switch and speed dial on control box.

Input Power- 120 volts A.C. 60 HZ single phase.

Specifications model MT-2C

Maximum weight capacity………………………….…………………...……...500 lbs

Tilting center of gravity measured from shaft centerline…………………….........6.0 inches

Rotation Eccentricity @ maximum capacity………………..……….…..…........2.0 inches

Rotation Speed…………………………………………………..………........0.25 to 2.5 rpm

Maximum Rotation Torque……………………………………………….........1000 inch-lbs

Hollow Bore Diameter………………………….…………………….…… 3.94 inches