MAC RS-1-INB-A Tank Turning Roll

Specifications MAC Model RS-1-INB Tank Turning Roll
 

• Input Power: AC 120 volt 60 Hz Single Phase
• Maximum load capacity per set of one drive roll and one idler roll: 2,200 lb.
• Maximum work-piece diameter: 59 in.
• Work-piece diameter range: 1.97 in. to 59.0 in. 
• Speed Range: 3.3 to 33 in./min.
• Approximate shipping weight per set: 380 lb.
  

Above: MAC Model RS-1-INB Tank Turning Roll turning a 16 inch diameter pipe.

Standard Features MAC Model RS-1-INB Tank Turning Roll 
 

• Hand held push button pendent control with maintained forward, stop, reverse and infinitely variable speed adjustment.
  
• On/off electric foot control with forward and reverse switch at control box.
  
• Adjustable roll to roll center distance for optimum contact angle.
  
• Heavy duty worm gear direct drive provides non slip power transfer to drive roll.
  
• All gears and bearings fully enclosed and lubricated for long life and safety.
  
• Separate drive roll & idler roll for short or long work-pieces.
  
• L.E.D. digital readout frequency display for adjusting roll speed.
  
• Stepped down low voltage (24 volt D.C.) operator controls.
  
• Rubber drive and idler rolls will not mar work-piece surface.

Above: MAC Model RS-1-INB Tank Turning Roll rubber drive and idler rolls will not mar work-piece surface.

Above: MAC Model RS-1-INB Tank Turning Roll electrical box

All-Fab Corp. has sold thousands of Tank Turning Rolls to satisfied customers all over North America.  Click the image below to see just a few of our Tank Turning Rolls used in production.