Welding Positioner - Model 804

All-Fab Corp. manufactures and distributes welding positioning equipment such as welding positioners, tank turning rolls, pipe welding positioners and welding chucks. We also buy and sell used weld positioners, turning rolls, pipe welding positioners and welding fabricating equipment. From small bench top weld positioners and pipe rolls to large 3-axis welding positioners and tank turning rolls; we have a model that will fit your needs.

If you are looking for a welding positioner, tank turning roll, welding chuck or related weld positioning equipment then you have come to the right place. All-Fab Corporation offers a complete line of welding positioners, tank turning rolls, welding chucks, manipulators and related welding equipment. We also buy and sell used weld positioners, pipe turning rolls, pipe welding positioners and fabricating equipment. Check out our welding industry resource links for all of your welding, fabricating, welding positioner, pipe welding, pipe cutting, and pipe fabricating needs.

Model 804 Welding Positioner

Welding Positioner Model 804 All Fab Corp

Model 804 with 504 and 1254

Model 804 welding positioners prior to assembly

Model 804 welding positioners ready to be shipped

The standard features for the Model 804 Welding Positioner

Solid state D.C. infinitely variable speed table rotation.
Heavy duty fully enclosed worm gear rotation drive.
On/off electric foot control.
Machined table with 4 tee slots.
400 amp welding ground at 100% duty cycle.
High frequency protected for Tig welding.
Clockwise and counter clockwise table rotation.
Heavy duty tilt worm gear reducer with spur gear final drive 0 to 135 degrees.
Extra heavy frame and construction
Locating hole on dead center of table for locating chucks and fixtures.

Specifications Model 804

Capacity at 4" Center of Gravity and 4" Eccentricity	800 lbs
Maximum Rotation Torque	3200 inch/lbs
Maximum Tilt Torque	6400 inch/lbs
Table Rotation Degrees	360°
Table Tilt Degrees	135°
Input Power	115 volt 60 Hz single phase
Rotation Motor	1/2 HP D.C.
Rotation Speed	infinitely variable .19 to 4.3 rpm
Tilt Speed	infinitely variable by hand
Table Diameter	20 inches
Tee Slots	(4) at 90° for standard ANSI 3/8" tee nuts
Length Overall	30 inches
Height Overall	28 3/8 inches
Width Overall	33 inches
Anchor Bolt Holes in Base	(4) for 3/8" anchor bolts
Weight Approximate	655 lbs

*800 lb capacity at 4" center of gravity and 4" eccentricity. In a continuing effort to improve our products all features and specifications subject to change without notice.

Back to All Fab positioners

From a small bench top welding positioner to large 3-axis welding positioners and tank turning rolls, and pipe welding equipment, All Fab has a positioner or tank turning roll that will fit your needs.