All-Fab Corp. manufactures and distributes welding positioning equipment such as welding positioners, tank turning rolls, pipe welding positioners and welding chucks. We also buy and sell used weld positioners, turning rolls, pipe welding positioners and welding fabricating equipment. From small bench top weld positioners and pipe rolls to large 3-axis welding positioners and tank turning rolls; we have a model that will fit your needs.

If you are looking for a welding positioner, tank turning roll, welding chuck or related weld positioning equipment then you have come to the right place. All-Fab Corporation offers a complete line of welding positioners, tank turning rolls, welding chucks, manipulators and related welding equipment. We also buy and sell used weld positioners, pipe turning rolls, pipe welding positioners and fabricating equipment. Check out our welding industry resource links for all of your welding, fabricating, welding positioner, pipe welding, pipe cutting, and pipe fabricating needs.

Welding Positioner Model 504

Model 504 Welding Positioner - All Fab Corp.

Back to new All Fab Welding Positioners

Standard Features Model 504 Welding Positioner

Solid state D.C. infinitely variable speed table rotation.
Heavy duty fully enclosed worm gear rotation drive.
On/off electric foot control.
Machined table with 4 tee slots.
400 amp welding ground at 100% duty cycle.
High frequency protected for Tig welding.
Clockwise and counter clockwise table rotation.
Heavy duty tilt worm gear reducer with spur gear final drive 0 to 135 degrees.
Extra heavy frame and construction
Locating hole on dead center of table for locating chucks and fixtures.

Specifications Model 504 Welding Positioner

Capacity at 4" Center of Gravity and 4" Eccentricity	500 lbs
Maximum Rotation Torque	2000 inch/lbs
Maximum Tilt Torque	4000 inch/lbs
Table Rotation Degrees	360°
Table Tilt Degrees	135°
Input Power	115 volt 60 Hz single phase
Rotation Motor	1/3 HP D.C.
Rotation Speed	infinitely variable .14 to 4.3 rpm
Tilt Speed	infinitely variable by hand
Table Diameter	20 inches
Tee Slots	(4) at 90° for standard ANSI 3/8" tee nuts
Length Overall	30 inches
Height Overall	28 3/8 inches
Width Overall	33 inches
Anchor Bolt Holes in Base	(4) for 3/8" anchor bolts
Weight Approximate	586 lbs

*500 lb capacity at 4" center of gravity and 4" eccentricity. In a continuing effort to improve our products all features and specifications subject to change without notice.

Back to new All Fab Welding Positioners

Home - All-Fab Advantage - Welding Positioners - Welding Chucks - Pipe Turning Rolls & Tank Turning Rolls
MAC welding equipment - Used metalworking machinery
Trade in or sell your surplus machinery - Torch Mounts and Torch Holders - Industry Resource Links
Contact Us

Site Index

From a small bench top welding positioner to large welding positioners and tank turning rolls, All-Fab Corp. has a welding positioner, tank turning roll or pipe welding equipment that will fit your needs.