All-Fab Corp. manufactures and distributes welding positioning equipment such as welding positioners, tank turning rolls, pipe welding positioners and welding chucks. We also buy and sell used weld positioners, turning rolls, pipe welding positioners and welding fabricating equipment. From small bench top weld positioners and pipe rolls to large 3-axis welding positioners and tank turning rolls; we have a model that will fit your needs.

Sales@allfabcorp.com

If you are looking for a welding positioner, tank turning roll, welding chuck or related weld positioning equipment then you have come to the right place. All-Fab Corporation offers a complete line of welding positioners, tank turning rolls, welding chucks, manipulators and related welding equipment. We also buy and sell used weld positioners, pipe turning rolls, pipe welding positioners and fabricating equipment. Check out our welding industry resource links for all of your welding, fabricating, welding positioner, pipe welding, pipe cutting, and pipe fabricating needs.

Model 202 Bench top Welding Positioner

Model 202 Benchtop Welding Positioner from All-Fab Corp.

Model 202 Welding Positioner shown with optional MT8 chuck

Click here for additional photos of the Model 202 Benchtop Welding Positioner.

Standard Features Model 202 Benchtop Welding Positioner

Solid state D.C. infinitely variable speed table rotation.
Heavy duty fully enclosed worm gear rotation drive. No belts or chains.
Heavy duty on/off electric foot control.
Machined table with 4 tee slots.
400 amp welding ground at 100% duty cycle.
High frequency protected for Tig welding.
Clockwise and counter clockwise table rotation.
Table tilting of 120 degrees in 15 degree increments.*
Extra heavy frame and construction
Locating hole on dead center of table for locating chucks and fixtures.

*Note: Total of 8 positions @ 15 degree spacing.

Specifications Model 202 Welding Positioner

Input Power	AC 120 volt 50/60 Hz single phase
Maximum load capacity	200 lbs
Tilting centroid at maximum capacity	2 Inches
Rotation centroid at maximum capacity	2 Inches
Rotation Torque	400 lb-inches
Table Rotation Degrees	360°
Table Tilt Degrees in 15 degree increments.	120°
Rotation Speed	infinitely variable .14 to 4.3 rpm
Tilt positions @ 15 degrees	8
Table Diameter	13 inches
Tee Slots	(4) at 90° for standard ANSI 3/8" tee nuts
Length Overall	20 inches
Height Overall	17 inches
Width Overall	18 inches
Anchor Bolt Holes in Base	(4) for 3/8" anchor bolts
Weight Approximate	198 lbs

Back to new All Fab positioners

From a small bench top welding positioner to large welding positioners and tank turning rolls, and pipe welding equipment, All Fab has a positioner or tank turning roll that will fit your needs.