If you are looking for a welding positioner, tank turning roll, welding chuck or related weld positioning equipment then you have come to the right place.  All-Fab Corporation offers a complete line of welding positioners, tank turning rolls, welding chucks, manipulators and related welding equipment.  We also buy and sell used weld positioners, pipe turning rolls, pipe welding positioners and fabricating equipment.   Check out our welding industry resource links for all of your welding, fabricating, welding positioner, pipe welding, pipe cutting, and pipe fabricating needs.


Home
Welding Positioners
Welding Chucks
Turning Rolls
Welding Industry Links
Used Machinery
Sell Surplus Machinery
All-Fab Advantage
MAC welding equipment
Contact Us

Model POK-07 Welding Positioner

Model 1508 Welding Positioner - All Fab Corp.

Photo of Model POK-07 welding positioner with machined 6 tee slotted table standard.

Model POK-07 Welding Positioner with WPT-600 chucks

Electrical of Model POK-07 Welding Positioner

Welding with model POK-07 Welding Positioner

The standard features for Model POK-07 Welding Positioner

  • Infinitely variable speed table rotation.
  • AC inverter on rotation drive with LED frequency display for speed adjustment.
  • Push button pendent control for power tilt and table rotation.
  • For and Rev foot control for table rotation.
  • 800 amp welding ground at 50% duty cycle.
  • Machined table with centering grooves.
  • Extra heavy worm gear drives and construction.
  • Tilt gear shaft supported at each end for long life.
  • 360 degree table rotation CW & CCW with power on indicator light.
  • High frequency protected for Tig welding.
  • Twice the tilt and rotation torque of standard 1500 lb units.

Specifications Model POK-07 Welding Positioner

Capacity at 8" Center of Gravity and 8" Eccentricity1500 lbs
Maximum Rotation Torque12000 inch/lbs
Maximum Tilt Torque20850 inch/lbs
Table Rotation Degrees360°
Table Tilt Degrees0 - 90°
Input Power230/460 3 Phase
Rotation MotorA.C. Inverter
Rotation Speedinfinitely variable 0.1 to 1.0 rpm
Tilt Speed90°/33 sec (60Hz)
Table Diameter24 inches
Tee Slots(6) at 60°
Length Overall41.3 inches
Height Overall29.5 inches
Width Overall30.5 inches
Anchor Bolt Holes in Base(4) for 1/2" anchor bolts
Weight Approximate1100 lbs

Back to new welding positioners

Home - All-Fab Advantage - Welding Positioners - Welding Chucks - Pipe Turning Rolls & Tank Turning Rolls
MAC welding equipment - Used metalworking machinery
Trade in or sell your surplus machinery - Torch Mounts and Torch Holders - Industry Resource Links
Contact Us


Site Index

From a small bench top welding positioner to large welding positioners and tank turning rolls, All-Fab Corp. has a welding positioner, tank turning roll or pipe welding equipment that will fit your needs.