All-Fab Corp. manufactures and distributes welding positioning equipment such as welding positioners, tank turning rolls, pipe welding positioners and welding chucks. We also buy and sell used weld positioners, turning rolls, pipe welding positioners and welding fabricating equipment. From small bench top weld positioners and pipe rolls to large 3-axis welding positioners and tank turning rolls; we have a model that will fit your needs.

If you are looking for a welding positioner, tank turning roll, welding chuck or related weld positioning equipment then you have come to the right place. All-Fab Corporation offers a complete line of welding positioners, tank turning rolls, welding chucks, manipulators and related welding equipment. We also buy and sell used weld positioners, pipe turning rolls, pipe welding positioners and fabricating equipment. Check out our welding industry resource links for all of your welding, fabricating, welding positioner, pipe welding, pipe cutting, and pipe fabricating needs.

Welding Positioner Model 1254

Welding Positioner Model 1254 with Welding Chucks from the welding positioner leader All Fab Corp. A leader in welding positioner and weld position equipment.

Model 1254 welding positioners ready for shipping

Model 1254 with 16 inch welding chuck and outboard support

Model 1254 with 804 and 504 welding positioners

Load Chart Model 1254 Welding Positioner

The standard features for the Model 1254 Welding Positioner

Solid state D.C. infinitely variable speed table rotation.
Heavy duty fully enclosed worm gear rotation drive.
On/off electric foot control.
Machined table with 3 tee slots.
400 amp welding ground at 100% duty cycle.
High frequency protected for Tig welding.
Clockwise and counter clockwise table rotation.
Heavy duty tilt worm gear reducer with spur gear final drive 0 to 135 degrees.
Extra heavy frame and construction
Locating hole on dead center of table for locating chucks and fixtures.

Specifications for Model 1254 Weld Positioner

Capacity at 4" Center of Gravity and 4" Eccentricity	1250 lbs
Maximum Rotation Torque	5000 inch/lbs
Maximum Tilt Torque	10625 inch/lbs
Table Rotation Degrees	360°
Table Tilt Degrees	135°
Input Power	115 volt 60 Hz single phase
Rotation Motor	1/2 HP D.C.
Rotation Speed	infinitely variable .06 to 1.4 rpm
Tilt Speed	infinitely variable by hand
Table Diameter	24 inches
Tee Slots	(3) at 120° for standard ANSI 5/8" tee nuts
Length Overall	38 inches
Height Overall	30 9/16 inches
Width Overall	40 inches
Anchor Bolt Holes in Base	(4) for 3/8" anchor bolts
Weight Approximate	897 lbs

*1250 lb capacity at 4" center of gravity and 4" eccentricity. In a continuing effort to improve our products all features and specifications subject to change without notice.

Back to new All Fab Corp welding positioners

Home - All-Fab Advantage - Welding Positioners - Welding Chucks - Pipe Turning Rolls & Tank Turning Rolls
Welding Handy Carriage - MAC welding equipment - Used metalworking machinery
Trade in or sell your surplus machinery - Torch Mounts and Torch Holders - Industry Resource Links
Contact Us

Site Index

From a small bench top welding positioner to large 3-axis welding positioners and tank turning rolls, All Fab has a welding positioner or tank turning roll that will fit your needs.