Standard Features Model EX-R5-A Tank Turning Rolls
Push Button Pendant
Control The hand held pendent
control features a maintained Forward Stop- Reverse push buttons along with a
variable speed control dial, Emergency Stop button and 32 feet of control cable.
Foot Control An on/off foot control
is also provided with forward and reverse switch located at the control box. A
quick release plug in at the control box allows the foot control to be quickly
and easily removed and stored when not in use.
LED frequency display for speed adjustment
An AC inverter drive provides infinitely variable roll speed, long life and
low maintenance. A sight window is provided at the control box to allow viewing
the LED frequency display which can be used to quickly and accurately adjust the
roll speed back to previous settings.
Low Voltage Controls The control voltage used in
the pendent, foot control and switches is stepped down to 24 volts DC and
fused at 0.5 amps for greater operator safety.
AC 120 Volts Input Power
The EX-R5 uses AC 120 volt 60 Hz single phase input power. Allowing the
rolls to be used anywhere in the shop.
Qty 2 Heavy Duty Gear
Drives Both drive rolls are powered by a heavy duty direct gear drive and
brake motor. All of the gears and bearings are fully sealed and
lubricated for long life and safety.
Roll to Roll Adjustment
- The roll to roll distance can be quickly and accurately adjusted
to accommodate a wide range of work-piece diameters. The EX-R5 has one
roll that is fixed and the other roll is moveable. The moveable roll is
set to the desired position according the work-piece diameter and then
locked into place with the lock pin. The whole process takes only
seconds. This system eliminates the many problems and time consumed
using drive shafts, couplings and bolts.
Heavy Duty Machined Frame
Both drive roll and idler frame are machined after fabrication for accuracy
and better alignment. This helps to reduce spiral out movement of the tank or
pipe when rotating.
Non Marring Rolls Both the drive and idler rolls are heavy duty iron core with extra
thick urethane for long life and traction. The rolls will not mar or scratch
materials such as stainless steel or aluminum.
Workmanship and Materials The model EX-R5 rolls are manufactured to world
class quality and come with a 1 year warranty. We maintain a complete
parts inventory available for immediate shipment if needed.
Specifications for Model EX-R5-A Turning Rolls
Maximum Load Capacity per
set of one drive roll and one idler roll
.. 11,000 lbs
Maximum Load Capacity for
drive roll only
.. 5500 lbs
Maximum Load Capacity for
idler roll only
.. 120 inches
.. 11.8 inches
Roll Speed Infinitely
. 4.3 to 43 inches/minute
. AC 120 volts 60 Hz Single Phase
.. 1050 lbs
84L x 44W x 26H
Back to Tank Turning Rolls Main Page
From a small bench top welding positioner to large
welding positioners and tank turning rolls, All Fab has a welding positioner or tank turning roll that will fit your needs.