If you are looking for a welding positioner, tank turning roll, welding chuck or related weld positioning equipment then you have come to the right place.  All-Fab Corporation offers a complete line of welding positioners, tank turning rolls, welding chucks, manipulators and related welding equipment.  We also buy and sell used weld positioners, pipe turning rolls, pipe welding positioners and fabricating equipment.   Check out our welding industry resource links for all of your welding, fabricating, welding positioner, pipe welding, pipe cutting, and pipe fabricating needs.


Home
 Welding Positioners
Welding Chucks
Turning Rolls
Welding Industry Links
Used Machinery
Sell Surplus Machinery
All-Fab Advantage
MAC welding equipment
Contact Us

 

The Model PB2005 Pipe Bully offers mechanical contractors and pipe shops a low cost, high quality solution for rotating pipe, tubing and solid shafts.  Used with an outboard roller support, the PB2005 can rotate a large diameter range of pipe smoothly and efficiently.  Click here to see a list of Pipe Bully benefits.

                                        Click on the small photos below for a larger view.

 

.

Model PB-2005 Pipe Bully

Model PB-2005 Pipe Bully shown with MT20 chuck and RS-20 outboard roller support, pipe diameter shown 16 inch.

 

*Click here for the Pipe Bully load chart

*Click here for Pipe Bully outline drawings

Model PB-2005 Pipe Bully Standard Features:

Rotation Drive – Massive heavy duty all worm gear rotation drive.  All of the gearing and bearings are fully sealed and lubricated for long life and safety.  There are no belts or chains to adjust or maintain.   

Variable Speed – Infinitely variable speed table rotation.  Solid state DC control in a dust tight Nema 4 enclosure.  The DC control features an adjustable acceleration, de-acceleration, Forward/Stop/Reverse switch and power on indicating light. 

Foot Control – Heavy Duty on/off foot control with 25 feet of cable.

Welding Ground – Tweco 400 amp at 100 percent duty cycle rotary welding ground for conducting the welding current.

Input Power – AC 120 volt 50/60 Hz single phase.  Easily located anywhere in the plant.

Frame – Heavy Duty Frame and construction fixture welded for accuracy.

Outboard Roller Support – An outboard roller support must be used for all pipe work.  The maximum load capacity for the model PB2005 when used with an outboard roller support is 2000 lbs.

Specifications Model PB-2005 Pipe Bully:

*Maximum weight capacity at 5 inch center of gravity..................2000 lbs

Maximum weight capacity using an outboard roller support.... .....2000 lbs

Maximum Rotation Torque.........................................................10,000 lb-inches

Table speed infinitely variable .....................................................0.06 to 1.4 rpm

Table diameter...........................................................................20 inches

Table fixed.................................................................................90 degrees to floor

Table centerline to floor..............................................................32 inches

Length at longest point...............................................................46.5 inches

Width at widest point.................................................................39.75 inches

Height at highest point................................................................47.75 inches

Approximate shipping weight with MT20 chuck.........................1289 lbs

*Note- Maximum load capacity measured from the faceplate (table).  Chucks, fixtures and gripping devices will add weight and additional distance to the center of gravity of the work-piece and must be taken into consideration when calculating the load.

Back to Pipe Bully Main Page